Homemade ATV based on a walk-behind tractor
The ATV has good maneuverability, maneuverability and a high level of safety.
It resembles a four-wheeled motorcycle. Often, an ATV is created on the basis of the Neva walk-behind tractor.
Step-by-step manufacturing scheme:
- Wheels are modified. In the unit, the wheels are set at the same distance from the body using factory adapters;
- The frame is being redesigned and strengthened. It is better to use a ready-made motorcycle base, which is strong enough and will not cause problems in the future;
- Disks are mounted. You can use low profile disks. It is possible to smooth out the friction between the rubber and the rim with special fabric pads;
- The tires are put on. Cameras from trucks are suitable. You can take wheels with low pressure. There is no need to install shock absorbers on the unit.
After simple steps, the finished ATV from a walk-behind tractor is tested on a country road.
Karakat based cultivator: distinctive features and assembly
The caracat from a walk-behind tractor is similar in purpose to the device discussed above. The differences are:
- extended wheelbase with belt clutch;
- bulkiness;
- extended conditions for operation - the karakat is capable of generating speeds of up to 70 km/h on rough terrain.
Due to the fact that the main emphasis in this alteration concerns the tires, we will dwell on them in more detail.
Among the existing methods of manually recreating powerful and large stingrays, several basic ones can be distinguished:
- considered the easiest. Two metal disks are taken and aggregated onto a sleeve. They put cameras on them, secured with a conveyor belt. The walk-behind tractor has good stability and endurance;
- Only one of the disks is attached to the hub. Jumpers are also installed on it. Rings are fitted to the latter welding machine;
- resembles the previous method, however, the central disk requires an additional spoke, which can be made from a metal billet or pipe;
- will allow you to give new life to disks from an old scooter, which are standardly attached to a hub.
You can use the proposed drawings as a reference outline for further assembly of the caracat.
A homemade caracat based on an engine from a soil cultivator such as “Neva” or “MTZ” is assembled as follows:
- we prepare a frame from a metal profile or pipes;
- We install front and rear wheel drive. It is allowed if they are without a differential and solid;
- the front axle can be borrowed from the chassis of the car. The steering rack is also taken from it;
- The engine is borrowed from the tillage machine. You can leave the original gearbox or replace it with a multi-stage gearbox. In this case, it will be easier to control speeds in karakat. With a gearbox, you will have to stop before changing the speed of movement;
- install the ramps and proceed to testing the Karakarta.
Buggy with motor from walk-behind tractor drawings
1. Perhaps it’s worth starting with the “Bucephalus” project of my pen pal Sanusha.
Perhaps the most elegant and simple design of a light buggy, which is based on exactly the same engine as mine - Lifan 190FR. 2. No less original is the buggy project of comrade vital-bmk from Mariupol. Of course, this is not a separate independent machine, but a branch of the main project, so the history of its creation will have to be separately read from the BZ.
3. We continue the review of wheeled vehicles
